Daytona D-Unit Easy Motorcycle Accessory Power Unit, 4-Channel, Centralized Power Management, 19.5A Total, Model 45865

This power unit allows you to smartly extract power for accessories from your battery. By consolidating all your accessories, such as ETC, USB, hot grips, aftermarket meters, and dashcams, into one location, you can reduce clutter and reduce wiring clutter. Simply strip the wiring and connect with one touch. Electrical equipment can be installed without the need for crimping tools. Power is turned on/off in conjunction with the main key, eliminating standby current consumption that can drain the battery. The LED indicator allows you to check continuity from outside the case. The built-in fuse can be changed to the required amperage (up to a total of 20A). A puller is included for easy fuse replacement. Input Voltage: DC12V Input Voltage Range: DC9V-16V Maximum Input Power: Approximately 0.6W Rated Current: 20A (Relay Unit) Relay Output Overcurrent Protection: Yes Output Short Protection: Depends on included fuse Input Harness Length: Approximately 600mm Output Harness Length: Approximately 200mm

Uses CA/CB103 size bullet terminals. A commercially available low-profile blade fuse is required to change the amperage. Output Wire Size: 1.25sq (1.3mm2/AWG16). A 2.2mm outer diameter is recommended. Manages accessory power supplies, including USB, in one location. Supports up to four accessories. 7.5A Output (1 port), 5A Output (2 ports), or 2A Output (1 port). Strip the wires and connect with one touch. Easy installation without crimping tools. Includes wire with a connector, allowing connection via a connector terminal. Power is turned on/off via the main key. No need to worry about a dead battery. Includes an LED indicator to check if the fuse is blown. The built-in fuse can be replaced to adjust the required amperage (up to 20A total).