Weighing Transmitter Sensor Industrial Supplies 4‑20mA Voltage Signal Output 0‑10V

Feature: 1. This transmitter adopts a sealed enclosure with a protection level of IP67. 2. The working temperature of the transmitter is ‑10 celsius 50 celsius , which is convenient and practical. 3. This weight transmitter can be used in various industrial environments with strong adaptability. 4. The signal output type of this weight senor transmitter can be 0 10V or 4 20mA. 5. This transmitter is simple to use, small in size, easy to carry and store. Specification: Item Type: Weighing Transmitter.Operating Temperature: 30 60 celsius Humidity: 10percent RH 85percent RH, non condensing. Storage Temperature: 40 celsius 85 celsius Appearance Size: Approx. 120 x 180 x 46mm 4.7 x 7.1 x 1.8inZero Adjustment Range: + 50percent FS Working Temperature: 10 celsius 50 celsius Output Fan Tail: 0 10V or 4 20mA Linear Accuracy: 0.05percent FS Power Input: DC18 24V Comprehensive Accuracy: 0.2percent FS Applicable Sensor Sensitivity: 1.0 3.0mV V Sensor Excitation Voltage: DC 12V, can drive 1 4 analog sensorsHow To Use: Current Output Adjustment: Take 4 20mA As An Example: Step 1: Connect and check according to the wiring diagram; Step 2: The load bearing device is at no load, use an ammeter to measure the current output, and adjust the potentiometer marked ZERO , that is, the zero point potentiometer, so that the current output is 4. 000mA. Step 3: Increase The Load bearing Device To Full Load (or A Certain intermediate load point: Npercent F. S), adjust the potentiometer marked SPAN , which is the gain potentiometer, so that the current output is 20.000mA (or 4+npercent x 16). Step 4: Repeat steps 2 and 3 until the result is correct. Voltage Output Adjustment: Take 0 10V As An Example: Step 1: Connect and check according to the wiring diagram; Step 2: The carrying device is at no load, measure the voltage output with a voltmeter, and adjust the potentiometer marked ZERO , which is the zero point potentiometer, to make the voltage output 0.00V. Step 3: Increase The Load bearing Device To Full Load (or A Certain load point in the middle: Npercent FS), adjust the potentiometer marked SPAN , that is, the gain potentiometer, so that the voltage output is 10. 000V (or 10 x npercent V) . Step 4: Repeat steps 2 and 3 until the result is correct. Package List: 1 x Weighing Transmitter