Tuningfan Shift Pattern Emblem - BLACK (Black) - For 5MT Vehicles - Low Back Pattern
Hairline base finish + clear dome coating
Size: 16mm (height) x 22mm (width) x approximately 2mm (thickness)
Made with non-yellowing polyurethane resin. Adhesive: Strong adhesive.
Made in Japan
Tuningfan Shift Pattern Emblem - BLACK (Black) - For 5MT vehicles
Part number: SPE-K502
We have responded to requests for a product that is "as simple as possible" and "unobtrusive" while maintaining the same quality as Tuningfan products.
"No decorative frame" and "Not too big" black shift pattern emblem
This pattern is commonly known as the low back, racing pattern, or Porsche pattern.
Porsche 901, BMW E30 M3, Sunny B110, B120, HB310, Violet
Ferrari 348, 328, Testarossa, 512TR
Elf, Generation Canter, Dutro, Toyoace
Recommended for:
Using a dome made of highly transparent polyurethane resin
It combines a three-dimensional, beautiful gloss with high durability thanks to UV protection.
Upgrade your interior with a touch of luxury that sets it apart from typical stickers.
This applies to all 5-speed manual transmission vehicles with the same pattern as indicated.
It can be installed simply by attaching it to the side of the shift boot or the shift panel.
The dimensions are 16mm (height) x 22mm (width) x approximately 2mm (thickness).
To ensure it can be applied anywhere, the dimensions are almost the same as the original shift pattern labels from car manufacturers, and the size is set to be not too large.
A simple and timeless design that eliminates unnecessary logos and decorations.
Tuningfan Original Product
By applying black to a metal hairline base,
It has a texture similar to anodized aluminum, where the color changes depending on the viewing angle.
*Shift knobs without a shift pattern printed on them will not pass vehicle inspection.
For driving on public roads, the installation of a shift pattern plate like this is mandatory.
Recommended for those with aftermarket shift knobs that do not have a pattern plate installed.
The adhesive in this product is made of the strongest possible material,
If there is dust or oil on the surface to which you are applying the sticker, the adhesive strength will inevitably decrease significantly.
If a polishing agent or similar has been applied,
Please remove any residue thoroughly using a parts cleaner or alcohol wipe before applying.
After peeling it off the separator (backing), carefully stick it on, making sure not to touch the adhesive surface.
Apply pressure to the entire surface and press firmly to ensure a tight fit.
It can take up to 24 hours for the adhesive to stabilize after initial adhesion.
Please avoid moving or repositioning it.
If the temperature is below 10 degrees Celsius, it will be difficult to apply, so use a hairdryer or similar device.
Please warm it slightly before applying.
Flat/gently curved surfaces made of common plastics (PE, PP)
This product is designed to be attached to interior panels.
For application to rough surfaces such as textured surfaces, curved surfaces, and soft-touch painted surfaces:
Please use the included double-sided tape (JIS "Super Strong" tape, manufactured by 3M).
Dome section: Polyurethane resin (non-yellowing)
Pattern markings: Hairline laser printing
Adhesive: Strong adhesive
Teslim edilmediğinde para iadesi
