Type-C 18650 Battery Charger UPS Module 15W Fast Charge Boost 5V 9V 12V Output for Camping Portable Power Supply

📌 Critical Pre-Purchase Reminder: Batteries are NOT included in the package. Please keep this in mind before you complete your purchase. ### Product Parameters Power Input: Compatible with DC5V or USB Type-C input Output Specs per Model: HW-465A (5V/3A), HW-465B (9V/1.6A), HW-465C (12V/1.2A) Maximum Rated Output Power: 15W Charge Cutoff Threshold: 4.2V ± 1% Low Battery Cutoff Protection: 2.5V Standby Power Draw: Approximately 10mA Use Cases: Perfect for providing non-stop power supply for network and surveillance gear including routers, switches, monitoring cameras, as well as infrared alarm systems across all usage scenarios.

### Standout Advantages • Automatically charges the connected battery when grid power is available, switches to battery power immediately during power outages to keep your devices running without interruption • On-board LED lights display real-time status clearly: charging, fully charged, and active output • Built-in multi-layer safety protection for lithium batteries: safeguards against overcharge, over-discharge, over-current and over-temperature hazards • Choose from 3 output voltage variants (5V, 9V, 12V) to perfectly fit your device's power requirements • Battery holder allows parallel connection of multiple battery units to ensure steady, reliable charge and discharge capacity • Two input options available: USB Type-C and DC5V, so you can pick the most convenient power source for your setup

### Operation Guide Step 1: Attach your lithium battery to the back battery holder, make sure positive and negative terminals are aligned correctly Step 2: Connect a 5V power source to the Type-C or DC input port Step 3: Wire your load device to the UPS positive and negative terminals Once connected: The on-board red output indicator will light up. When you connect a standard phone charger and data cable to the Type-C port, the charging indicator will show whether the battery is still charging or already full. When external power is supplied, the unit powers your connected load and charges the battery at the same time (please use an input power supply with 3A or higher output for this function). When external power is disconnected, it switches to battery power instantly with zero delay. If battery voltage drops below 2.5V, over-discharge protection triggers to shut off output. The red output light will flash if overheating or overload is detected, meaning protection mode is activated. *You can connect multiple batteries in parallel via the battery holder for even more stable charge and discharge performance.

### Safety Notes 1. Always follow the official wiring diagram to avoid miswiring 2. Double check the positive and negative orientation of your battery before connecting, incorrect polarity may damage the device permanently 3. If the unit gets excessively hot during simultaneous charging and discharging, please install extra cooling to avoid overheating 4. If output stops working due to miswiring or accidental short circuit during use, resolve the issue first, then reconnect to a 5V USB power source to reset and reactivate the output. The merchant warrants that their products comply with all applicable laws, and are offered only if they comply with Joom's policies and EU Product Safety and Compliance laws.